Tuesday, December 27, 2016

Air Source Heat Pump Heating Floor Maintenance Points



1. Whether you need a local warming, air source heat add antifreeze?
Air source heat pump for heating floor can add a certain amount of antifreeze, project traders can according to the size of floor heating and the corresponding percentage of antifreeze.
In order to reduce the cost of the operation of the air can heat pump floor heating can try this way: when away from home during the day, can be used in a low temperature heating, raise the temperature in a timely manner after go home, enjoy a comfortable warm home life.

2. Air source heat pump heating floor stopped in winter and summer?
A, The area below 0 degrees in winter, could freeze period, if a short period of time (3-5 days) was not at home, can be machine stop, but must do not power;Air source heat pump floor heating unit now has its own antifreeze protection function, the function of automatic stop to prevent frostbite.
The correct antifreezing measures should be:
a) Short time (within a week) no person in the home, can be set to the lowest temperature, the domestic heat pump will run at the bottom temperature.
b) Home empty for a long time, but will all the water in the air source heat pump floor heating system drain and clean.But note that, before the operation, please give full consideration to indoor and other lines, such as water pipe will never freeze.
B, Need not when in the summer, long time no one in the home or for a long time not to use and not freezing can shut down the unit;Disconnect the power, put the water system of water to dry. But for security reasons, in the case of not live for a long time, must be on the water system after cut off power supply.  

domestic heat pump


3. When air source heat pump heating floor clean screen pack what to drain?
Air source heat pump heating floor heating water drainage method: close cold water inlet valve and open the water valve, open the sanitary hot water faucet, heating water discharge.Contrarian recharging water can run, can be turned on.

4.  Air source heat pump floor heating temperature couldn't get on?
a, The heat radiator is not enough, the problem easily happened in the replacement of the radiator user home.Add radiator big to small, the heat coming from the radiator is not enough to compensate for the heat loss of the room.
b, Wet room did not work, because the wall is wet, the water cut of gasification and to absorb a large amount of heat, therefore, room temperature curing barn takes about a week's time.
c, Starting and stopping, room temperature is not in balance, namely to turn it off;And heat coming from the early also because between families turn heat is absorbed by the outside world, so always can not meet the requirements of the temperature.

No comments:

Post a Comment